Deadfalls and Snares - The Original Classic Edition by Harding A | Paperback | Barnes & Noble
Deadfalls and Snares - The Original Classic Edition

Deadfalls and Snares - The Original Classic Edition

by A. R. Harding
     
 

View All Available Formats & Editions

Deadfalls and Snares by A. R. Harding - The Original Classic Edition

Finally available, a high quality book of the original classic edition.

This is a new and freshly published edition of this culturally important work, which is now, at last, again available to you.

Enjoy this classic work today. These selected paragraphs distill the contents and give you a

Overview

Deadfalls and Snares by A. R. Harding - The Original Classic Edition

Finally available, a high quality book of the original classic edition.

This is a new and freshly published edition of this culturally important work, which is now, at last, again available to you.

Enjoy this classic work today. These selected paragraphs distill the contents and give you a quick look inside:

The figure 4 trigger is best for this trap and is made after this manner: standard (1) is made by cutting a stick five or six inches long out of hard wood and whittling it to a flat point, but blunt at one end; (2) is about five inches long with a notch cut within about one and one-half inches of the end with the other end made square so that it will fit in (3) which is the bait stick.

...For upright pieces to hold the main pieces so one would fall square on the other, we used sawed stuff 1 x 3, two pieces set straight up and down at each end, or about far enough to leave the back end stick out three inches, and front end or end where the triggers set, 6 inches.

Nail these 1 x 3 two on each end as directed above, nail to lower piece 2 x 4 only, then at back end bore a hole through the two uprights and also upper 2 x 4, or the piece that falls, put a bolt through, or a wood pin if the hole in the 2 x 4 is larger than those through the uprights; then you are ready to raise it up and let it drop to see whether it works smoothly or not.

...A good way to get your material is to go to the saw-mill, select good straight-grained 2 x 4 studding, have them ripped lengthwise again, making four strips out of the original 2 x 4, each strip being two inches wide by one inch thick; then have them cut in the lengths - two standards (A), 14 inches long; (B) two side pieces, 2 1/2 feet long; (C) two drop bars, 2 1/2 feet.

...Take two pieces of No. 9 fence wire about 30 inches long, writes an Ohio coon hunter and trapper, file one end sharp, then commence at each hind foot and punch the wire thru close to the edge as in sewing, taking stitches an inch or so long until you get to the front foot, then pull the hide along the wire just far enough so the top and bottom will stretch out to make it square, or a few inches longer than the width is better.

Product Details

ISBN-13:
9781486151745
Publisher:
Emereo Pty Ltd
Publication date:
06/15/2012
Pages:
52
Product dimensions:
7.44(w) x 9.69(h) x 0.11(d)

Related Subjects

Customer Reviews

Average Review:

Write a Review

and post it to your social network

     

Most Helpful Customer Reviews

See all customer reviews >