| 1 | Bosch Fuel Injection--An Overview | |
| Introduction to fuel Injection and engine management | |
| Air-fuel mixtures | |
| Fuel delivery | |
| Carburetors vs. fuel Injection | |
| Types of Bosch fuel injection | |
| What is engine management? | |
| The Bosch Jetronic family | |
| Listing of cars equipped with Bosch systems covered in this book | |
| 2 | Engine Management Fundamentals | |
| Basic factors: Air-fuel mixture, stoichiometric ratio, Lambda | |
| Operating conditions and driveability: Warm and cold start-up, warm-up, cruising and accelerating | |
| Effects of altitude and other external factors | |
| Emission controls: EGR, AIR, catalytic converters | |
| Control systems | |
| 3 | Pulsed Injection--Theory | |
| Pulsed injection identification and applications | |
| L-Jetronic: Design and operation, componentry, circuitry | |
| LH-Jetronic: Design and operation, system signals, stabilization and adjustment | |
| Motronic: Data mapping, "Drive-by-wire" electronic throttle | |
| D-Jetronic | |
| Digifant II | |
| 4 | Pulsed Injection--Troubleshooting & Service | |
| Troubleshooting the system | |
| Checking the fuel delivery system from tank to injector tip | |
| Testing during starting and warm-up | |
| Air-flow measurement: Air-flow sensor, air-mass sensor, throttle switches | |
| Idle speed testing and adjustment | |
| Idle mixture (CO) and Lambda control | |
| Motronic timing and dwell | |
| 5 | Continuous Injection--Theory | |
| CIS identification and applications | |
| Air-flow system: Control plunger; backfire protection | |
| Fuel system: Accumulation and distribution, regulating system pressure | |
| Fuel metering: governing differential pressure | |
| Control systems: pressure drop | |
| Functions and compensations | |
| KE3-Jetronic and KE-Motronic | |
| 6 | Continuous Injection--Troubleshooting & Service | |
| Troubleshooting the system | |
| Air-flow measurement | |
| Checking the fuel delivery system | |
| K-basic, K-Lambda and KE-Jetronic control systems: Checking fuel, system, lower-chamber and residual pressure, pressure-actuator current | |
| Reading fault codes | |
| Idle RPM and mixture (CO) | |
| 7 | Tuning for Performance and Economy | |
| Legal issues | |
| High performance with driveability | |
| Injection system improvements and tricks | |
| Street and track performance systems | |
| 8 | Appendix | |
| SAE and Bosch terminology | |
| Pressure conversion table | |
| 9 | Glossary | |
| Clear and concise definitions of terms used in this book | |
| 10 | Index | |
| Comprehensive alphabetical guide to this book | |
